Controllers & programmers

Carbolite 300

• A low cost on/off version of the 201.
• No ramp to setpoint.
• Limited control stability

 

Carbolite 301

• A PID controller with a large display mounted behind a smooth wipe-clean membrane.
• Single ramp to setpoint facility Incorporates a process timer function.
• RS232 comms is available as an option at time of order.
• Made by Eurotherm exclusively for Carbolite.

Eurotherm 3216P1

• Made exclusively for Carbolite by Eurotherm.
• An advanced setpoint programming temperature controller with 8 segment pairs, each a ramp and a dwell.
• This configuration of a ramp followed by a dwell cannot be altered.
• Provides precise control with an advanced PID control algorithm giving stable straight-line control of the process.
• Power feedback is used to stabilise the output power and henced the controlled temperature against supply voltage fluctuations.
• The controller continually corrects for drift and this gives high stability and rapid response to process changes.

Eurotherm 3216P5

• Like the Eurotherm 3216P1, except that 5 different programs may be stored for later retrieval.
• The programs cannot be linked.
• Also made by Eurotherm for Carbolite

Eurotherm 3508P1

• An advanced setpoint programming temperature controller with twenty segments, any of which may be a ramp, a step or a dwell.
• Housed in a quick release 1/8 din size measuring 48 x 96mm high.
• Features large numeric and text displays to provide additional information of current status to the user.
• Provides the same precise control as the 3216P1 model.

Eurotherm 3508P10 & 3508P25

• Like the 3508P1, but has 10 programs with a total of 50* available segments and 25 programs of 100* respectively.
• Example : a single program of 50 segments could be created.
• The programs may be linked.
• * - The number of segments in the multi-segment models will be increased during 2005.

Overtemperature protection

• Eurotherm 2132 or integrated into 201
• Recommended for use on any unit left unattended overnight
• Housed in a compact 1/32 din size measuring 24 x 48mm wide or integrated into the 201 control panel
• The additional control unit uses a separate thermocouple and operates a contactor to shut down the furnace in the event of the set temperature being exceeded
• The adjustability of the limiting temperature means that the system may be set to protect either the furnace itself, or at a lower temperature a valuable load inside

Calibration certificates

• Various calibration certificates can be provided at the time of the units' manufacture
• For the thermcouple, at three points of your choice
• The certificate is issued by an independent UCAS/NAMAS accredited laboratory, traceable to UK national standards
• For the controller, at three points of your choice
• The certificate is issued by the controller manufacturer
• For thermocouple and controller combined
• The certificate is issued by an independent UCAS/NAMAS accredited laboratory, traceable to UK national standards

Communications & software

• Digital communications can be fitted using
• RS232
• RS485
• or RS485/RS422 via converter
• Data tranmission or data logging can be achieved using software from the iTools range

Chart recorders and DAQs

• A wide range of chart recorders can be fitted
• Single channel
• Dual channel
• or six channel
• A wide range of DAQs are also available, complete with software for reviewing off-line, via a remote computer
• Six channel
• or twelve channel
• Recorders can be provided with calibration certificates