| Ana-Box Closed Loop Analog Sensor Interface |
|
Foot Switch |
- Vary the pumping rate in proportion to a variable voltage input
- Start or stop pump at set voltages
- Vary the pumping rate to maintain a voltage window
- Attaches to any pump in the NE-1000 Family
|
|
-
Start, stop, or trigger the next phase on your syringe pump
-
Attach to any of the NE-1000 family pumps to allow stand-alone operation
-
Utilizes the TTL logic port on syringe pump
-
Quick and simple setup
|
| Pump to PC Primary Network Cable |
|
RS-232 to USB Converter |
CBL-PC-PUMP-7 (7ft. cable)
CBL-PC-PUMP-25 (25ft. cable)
- Allows full control over syringe pumps through your computer
- DB-9 adapter connects to 9-pin serial port (25-pin adapters available upon request)
- Utilizes the RS-232 communications port of syringe pump
- Available in 7' and 25' length cable
- Quick and simple setup
|
|
CBL-USB232
- Adapter to add a DB-9 RS-232 serial port to your computer by using an USB port
- Includes software driver CD
|
| Pump to Pump Secondary Network Cables |
|
Pump Synchronization Cables |
CBL-NET-7 (7 ft. cable) CBL-NET-25 (25ft. cable)
-
Allows networking of two or more syringe pumps to a single computer
-
Quick and simple setup
-
Utilizes the RS-232 communications port of syringe pump
-
Available in 7' and 25' length cable
-
Requires first pump to be connected with primary network cable
|
|
CBL-DUAL
-
Used for creating a continuous infusion system or dual infusion system
-
Establishes a communications link between two pumps to duplicate the exact or inverse commands issued to one pump.
-
Utilizes the RS-232 logic port on syringe pump
-
Quick and simple setup
-
This is the new replacement cable for CBL-TTL-1 unless the use of the TTL ports for synchronization is preferred
|
| Lockout Disable Key |
CBL-TTL-1
- Used for creating a continuous infusion system or dual infusion system
- Synchronize pumping direction of two syringe pumps so that they change directions, start, and stop as one unit
- Utilizes the TTL logic port on syringe pump - See new version above for using the RS-232 ports
- 7' cable
- Quick and simple setup
|
ADPT-LOCKOUT
-
For use with the syringe pump's "Lockout Mode"
-
Prevent unauthorized or accidental changes to the settings by locking the keypad
-
The "Lockout Disable" key unlocks the keypad and allows settings to be changed
-
Utilizes the TTL logic port on syringe pump
-
Quick and simple setup
|
| |
|
|
| OEM Starter Kit: For NE-5xx OEM models only |
|
|
OEM-STARTER
-
Allows user to interactively communicate to the pump with a computer
-
Includes: power supply, Pump to PC network cable (CBL-PC-PUMP-7), and user manual
OEM-NET
Power supply and secondary cable only. For use when networking two or more OEM NE-500 syringe pumps together. Must use the secondary cable in order to complete this application.
|
|
|
| |
***Not for clinical use on humans*** |
| <<< Go Back |
